Como modificar el deposito de una Gs 1200 08

Remove both side panels, via dzus fasteners & plastic quarter turn fastener inside, by forks.

Undo the six filler cap screws (if you open the filler cap & stuff clean rag in you'll stop metal swarf from entering the fuel tank or accidentally dropping a screw in!).....

Then undo two screws near the beak & two which hold the bottom of the the metal panels to the fuel tank and the whole painted tank top & metal side panels come off as one.

I then wrapped another piece of rag under the metal filler neck flange which now has about 2cm movement, restricted by internal plumbing. This rag is again to stop drilling swarf from entering the tank.

Then drill the holes & reassemble.

Clearly this whole exercise is unecessary if you don't mind waiting ages at petrol stations for it to cough & splutter fuel everywhere while you fill it to about 90% of it's capacity..........besides it was pissing down with rain here today & I didn't have anything better to do!!


http://www.ukgser.com/forums/showthread.php?t=23544&highlight=tank+modification